Press/hold Select and Run/Stop at the same time
- Green LEDs: Solenoid valves attached
- Red LEDs: Faulty solenoid valves detected
How to Control Your Smart Sprinkler Using Only the Instant Buttons
No phone? No Wi-Fi? No problem! The Yardian Pro still works
May 14, 2021
No phone? No Wi-Fi? No problem! The Yardian Pro smart sprinkler controller works even when your phone, app, or Wi-Fi don’t. The on-device control buttons on the controller allow you to start or stop specific zones as well as set the duration – all without the need for a smartphone. You can also check the connection and status of your sprinkler valves directly on the device.
The Yardian Pro gives you easy access to all the functions you need to maintain a healthy yard, even when you can’t find your phone. What’s more, the instant buttons let you give some control to friends or gardeners without having to provide them with app access. Follow the steps below and try the feature out today!
Follow The Steps Below
Auto Scan
Check the connection and status of valves
Instant Control
Run a zone for a specified duration or stop a zone
1
Select a zone
Click Select on the top to specify a zone in Zone Selection Mode (green LEDs)
2
Set the duration time
- Press/hold Select for over 1 second to switch between Zone Selection Mode and Time Selection Mode (red LEDs)
- Click Select to specify duration in min(s) in Time Selection Mode
Note: One red light refers to 1 minute, two red lights refer to 2 minutes, and so on. You can specify up to 12 minutes of watering time for a zone using the instant buttons.
3
Run the zone
Click Run/Stop to run the zone
4
Stop the zone
To stop watering at any time, press/hold Run/Stop for over 3 seconds
Visit our Support Center for more FAQs about Hardware and Installation if you need any other assistance.
